Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
- Install the EBCM to the BPMV.
- Install the EBCM-to-BPMV attaching screws. Tighten the bolts in a cross pattern.
Tighten:Β Tighten the bolts to 3 N.m (27 lb in).
- Connect the pump motor electrical connector.
- Connect the electrical connector to the EBCM.
- Reposition the TCM, if equipped, to the mounting bracket.
- Turn the ignition switch to the ON position. DO NOT start engine.
- Perform the Diagnostic System Check - ABSΒ .
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
