2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Aztek and 2002 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY (AZTEK) .
    Fig 1: Removing Instrument Panel Accessory Trim Plate
    G01747237Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolts/screws from the switch bank to instrument panel.
  3. Pull straight out from the instrument panel in order to remove the switch bank from the instrument panel.
    Fig 2: Removing Switch Bank & Screws
    G01747238Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connectors.
    Fig 3: Disconnecting Electrical Connectors
    G01747239Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.