2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Scan Tool Output Controls

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls

Scan Tool Output Control Additional Menu Selection(s) Description
Inadvertent Power Relay Inadvertent Power The BCM commands the Inadvertent Power Relay On/Off controlling power to interior lamps.
Load Management Miscellaneous Test The BCM controls the Load Management Relay, commanding it ON or OFF to enable or disable high current loads.
Retained Accessory Power Miscellaneous Test The BCM activates the RAP relay when you select ON. All systems powered by the RAP Relay should be active until commanded OFF.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.