2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Removal (Aztek 3.4L): Notes

  1. Remove the battery ground (negative) cable from the battery.
    2. Fig 1: View Of Wiper Module Cover
    GM776385Courtesy of GENERAL MOTORS COMPANY
  2. Rotate and secure the engine forward. See Rotating the Engine for Service Access .
    3. Fig 2: View Of Generator Electrical Leads, Connectors & Terminal Nut
    GM368797Courtesy of GENERAL MOTORS COMPANY
  3. Remove the generator B+ terminal nut.
  4. Remove the generator B+ lead.
  5. Remove the generator electrical connector.
  6. Remove the drive belt from the generator.
    7. Fig 3: Locating Generator Front Bolt
    GM368802Courtesy of GENERAL MOTORS COMPANY
  7. Remove the generator front bolt.
    8. Fig 4: Identifying Generator Rear Bolts
    GM368803Courtesy of GENERAL MOTORS COMPANY
  8. Remove the generator rear bolts.
    9. Fig 5: Aligning Generator To Generator Bracket
    GM368801Courtesy of GENERAL MOTORS COMPANY
  9. Remove the generator from the generator bracket and position the generator above the drive axle.
  10. Remove the drive belt tensioner.
  11. Remove the generator bracket.
  12. Remove the power steering pipes from the power steering pipe retainer.
  13. Remove the fuel pressure test port (schrader valve) cap from the fuel injector rail.
    14. IMPORTANT: Do not disconnect the power steering pipes from the power steering pump.
  14. Remove the power steering pump and reposition the power steering pump in front of the timing chain cover in order to provide access for the generator.
  15. Remove electrical harness from retainer on right fender well and position aside.
  16. Remove the generator from the vehicle.
Chapter Navigation
Return to Chapter: Removal (Aztek 3.4L)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.