Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Test C: Power Windows Inoperative Lockout Function
- Review power window description and operation. See DESCRIPTION & OPERATION . Perform preliminary inspection. See PRELIMINARY INSPECTION under TROUBLE SHOOTING. After performing inspection, go to next step.
- Operate power window system with passenger window lockout function activated. If lockout function does not operate normally, go to next step. If lockout function operates normally, power window concern may be intermittent. For aid in diagnosing intermittent problems, see PROBLEM DIAGNOSIS under INTERMITTENTS.
- Disconnect master window switch 6-pin Blue harness connector C1. Master window switch is located on drivers door panel. Turn ignition switch to RUN position. Using a test light connected to ground, probe master window switch harness connector C1 terminal "D" (Dark Blue wire). See Figure . If test light illuminates, go to next step. If test light does not illuminate, go to step 5 .
- Repair short to voltage in Dark Blue wire between master window switch harness connector C1 terminal "D" and center console fuse block harness connector C2 terminal F9. See Figure and Figure . If problem is found, repair as necessary and go to step 6 . If no problem is found, go to next step.
- Replace master window switch. See MASTER WINDOW SWITCH under REMOVAL & INSTALLATION. After repairs are made, go to next step.
- Check power window system for proper operation. If system operates properly, test is complete. If system does not operate properly, go to step 3 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.