2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Window Motor (Rear): Installation

  1. Install rear window regulator bolts half way into rear window regulator motor and rail.
  2. Position window regulator rail through rear access hole first.
  3. Position window regulator motor through rear access hole.
  4. Install window regulator into key slots. Attach regulator to motor and rail. Secure regulator with bolts. Tighten bolts to 97 INCH lbs. (11 N.m).
  5. Remove tape and position rear window to regulator carrier plate.
  6. Connect window to regulator carrier plate.
  7. Connect harness connector to rear window regulator motor.
  8. Install rear speaker.
  9. Install water deflector.
  10. Install trim panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.