Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Window Motor (Front): Installation

Install front window regulator bolts half way into window regulator motor and rail.
Position front window regulator rail through rear access hole first.
Position front window regulator motor through rear access hole.
Install front window regulator into key slots. Attach regulator to motor and rail. Secure regulator with bolts. Tighten bolts to 97 INCH lbs. (11 N.m).
Remove tape and position front window to regulator carrier plate.
Connect window to regulator carrier plate.
Connect harness connector to front window regulator motor.
Install water deflector.
Install door trim panel.

Fig 1: Removing & Installing Window Regulator & Power Window Motor

Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: Window Motor (Front)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.