2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Right Front Window Switch: Removal

  1. Remove passenger front window switch plate from passengers door trim panel using a small flat-bladed tool at front of power window control plate.
  2. Disconnect harness connector from passenger door window control switch.
  3. Remove power window control switch plate from front door trim panel. See Figure .
  4. Remove passenger front window switch (1) from front door window switch plate using a small flat-bladed tool.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.