2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Programming Remote Keyless Entry Transmitters

  1. Close vehicle doors.
  2. Turn ignition switch to OFF position.
  3. Remove ignition key from lock cylinder.
  4. Press and hold driver's side door lock switch to unlock position.
  5. Insert ignition key into lock cylinder and remove key. (Do not turn ignition key in lock cylinder.)
  6. Insert ignition key into lock cylinder and remove key. (Do not turn ignition key in lock cylinder.)
  7. Insert ignition key into lock cylinder. (Do not turn ignition key in lock cylinder.) Leave the key in lock cylinder.
  8. Release door lock switch. Body Control Module (BCM) will sound three beeps in order to verify PROGRAM MODE has been activated.
  9. Press lock and unlock buttons on keyless entry transmitter simultaneously for approximately 5 seconds. BCM will sound two beeps in order to verify transmitter has been successfully programmed.
  10. Perform previous step to program up to four transmitters.
  11. Remove ignition key from lock cylinder in order to exit PROGRAM MODE.
  12. Verify proper operation of each transmitter.
Chapter Navigation
Return to Chapter: Transmitter Programming
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.