2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Theft Deterrent Control Module: Removal

  1. Disable air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article.
  2. Remove steering column trim covers. See STEERING COLUMN SWITCHES - AZTEK article.
  3. Remove theft deterrent module wiring harness from steering column wiring harness.
  4. Disconnect harness connector.
  5. Pull theft deterrent module (2) away from lock cylinder housing (1). See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.