Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Theft Deterrent Control Module: Installation
- Push theft deterrent module (2), onto lock cylinder housing (1). See Fig 1.
- Install theft deterrent wiring harness to steering column harness.
- Connect harness connector.
- Replace steering column trim covers.
- Enable air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article.
- Program new theft control module. See PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS under PROGRAMMING.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.