Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Head Up Display Module: Installation

Install HUD module.
Install bolts that secure Heads Up Display (HUD) module to instrument panel. Tighten bolts to 18 INCH lbs. (2 N.m).
Connect harness connectors.
Install instrument panel upper trim pad, by reversing removal procedure steps 1 - 11 .

Fig 1: Removing & Installing Head Up Display Module

Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: Head Up Display Module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.