Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Body Control Module: Removal
NOTE:
When replacing the Body Control Module (BCM) BCM setup must be performed. See BODY CONTROL MODULE PROGRAMMING - REGULAR PRODUCTION OPTION CONFIGURATION under PROGRAMMING.
- Disconnect negative battery cable.
- Remove center console electrical center. See CENTER CONSOLE ELECTRICAL CENTER REPLACEMENT .
- Rotate BCM retaining lever (2) to release BCM from center console fuse block. See Figure.
- Remove BCM (1) from center console fuse block.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.