Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Serial Data Messages
Modules that depend exclusively on serial data messages for power modes stay in the state dictated by last valid PMM message until they can check engine run flag status on serial data circuits. If PMM fails, modules monitor the serial data circuit for engine run flag serial data. If the engine run flag serial data is true, indicating engine is running, the modules fail-safe to "RUN". In this state modules and their subsystems can support all operator requirements. If engine run flag serial data is false, indicating engine is not running, modules fail-safe to "OFF-AWAKE". In this state modules are constantly checking for a change status message on serial data circuits and can respond to both local inputs and serial data inputs from other modules on vehicle.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
