Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Serial Data Control of Retained Accessory Power
Modules listed below all receive a Retained Accessory Power (RAP) messages from Body Control Module (BCM) over class 2 serial data circuit. BCM monitors ignition switch position, battery condition and passenger compartment door status to determine whether RAP should be initiated. BCM then sends a message to listed modules initializing RAP power mode. Modules then support operation of systems as required by RAP power mode strategy of individual modules.
RAP will end when any of following conditions are met:
- BCM receives a hardwired input indicating opening of a passenger compartment door.
- After 10 minutes BCM receives message from internal timer indicating end of RAP period.
- BCM detects a decrease in battery capacity below a prescribed limit. BCM then sends a serial data message to listed modules ending RAP function.
The modules receiving class 2 serial data messages for RAP functions are:
- Radio.
- Instrument panel cluster.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
