Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Cylinder Bore Data/Specifications
| Water Jacket Drain Plug | 11 |
| Oil Gallery Plug (Large) - at Rear of Engine Block | 24 |
| Oil Gallery Plug (Small) - at Rear of Engine Block | 11 |
| Oil Gallery Plugs - at Side of Block above Oil Filter | 15 |
| Cylinder Bore Diameter | 3.5036 - 3.5043 |
| Cylinder Bore Out Of Round Maximum | 0.0005 |
| cylinder Bore Taper - Thrust Side Maximum | 0.0005 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
