2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

Cylinder Block Replacement Specification

Factory service manual diagram





Part 1 of 3

Factory service manual diagram





Part 2 of 3

Factory service manual diagram





Part 3 of 3

CYLINDER BLOCK REPLACEMENT SPECIFICATION
Block surface may be reconditioned by parallel grinding.
Use a straight edge and feeler gauge to check the deck surface for flatness.
1. Replace block if more than 0.254 mm (0.010 in) must be removed.
2. If the warpage is less than 0.076mm (0.003 in), reuse the cylinder head but do not resurface.
3. If the warpage is between 0.076mm (0.003 in) and 0.25mm (0.010 in), resurface the cylinder head before reusing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.