Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Brake System Specifications
FRONT BRAKE ROTORS
Rotor Diameter 259.0 mm (10.197 in.)
Installed Lateral Runout 0.08 mm (0.003 in.)
Thickness Variation 0.025 mm (0.001 in.)
FRONT BRAKE ROTOR THICKNESS
Minimum Thickness after Refinish 18.776 mm (0.739 in.)
Discard Thickness 18.70 mm (0.736 in.)
Rotor Thickness - New 19.96 mm (0.786 in.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
