Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
| Front Caster | 4.3 Degrees (deg) +/- 1.00 Degrees |
| Front Camber | 0.00 Degrees (deg) +/-1.00 Degrees |
| Individual Toe Measure the above toe angles with the steering wheel at level position, visually aligned with the column. | 0.00 Degrees (deg) +/- 0.12 Degrees |
| Sum Toe | 0.00 Degrees (deg) +/- 0.25 Degrees |
| Cross Camber Slight cross camber specification differences can be made when servicing the vehicle for steering pull. | 0.00 Degrees (deg) +/- 1.00 Degrees |
| Cross Caster | 0.00 Degrees (deg) +/-1.00 Degrees |
| Rear Camber | -0.40 Degrees (deg) +/- 0.75 Degrees |
| Rear Sum Toe | 0.20 Degrees (deg) +/- 0.30 Degrees |
| Rear Thrust Angle | 0.00 Degrees (deg) +/- 0.25 Degrees |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
