2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

Electronic Ignition Control Module (ICM)

The electronic Ignition Control Module (ICM) monitors the CKP sensor signals and based on these signals, sends a 7X reference signal to the PCM so that correct spark timing and fuel injector control can be maintained during all crank and run conditions. Since the PCM controls spark timing and ignition control during crank and run, there is no bypass mode.

The ICM is not repairable. When a module is diagnosed to be faulty, it is replaced as a separate component.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.