2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

PCM Replacement/Programming

The replacement Powertrain Control Module (PCM) must be reprogrammed and the crankshaft position system variation learn procedure must be performed. Refer to the following procedures:
^ Latest Techline information on PCM re-programming
^ CKP System Variation Learn Procedure
^ Password Learn Procedure
- Programming and Relearning

See the Introduction in Powertrain Control Module (PCM) Description for more information on using the diagnostic functions of the PCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.