Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Ignition Control Module: Service and Repair
REMOVAL PROCEDURE
1. Remove the air cleaner outlet from the air cleaner.
2. Remove the ICM electrical connectors (1) and spark plug wires (2).
3. Remove the ignition coils bolts (3).
4. Remove the ignition coils and ICM assembly.
INSTALLATION PROCEDURE
1. Install the ICM assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the ignition coils.
Tighten
Tighten the ignition coils bolts (3) to 4 N.m (35 lb in).
3. Reinstall the spark plug wires (2) and ICM electrical connectors (1).
4. Reinstall the air cleaner outlet duct to the air cleaner.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
