2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

Ignition Control (IC)

This system uses the same circuits between the ICM and the PCM that distributor type systems use. Following is a brief description for each of the IC circuits.
^ Crankshaft position (CKP) sensor activity (7X reference)-The CKP sensor generates a signal to the ICM which results in a reference pulse, square wave signal, being sent to the PCM. The PCM uses this signal to calculate crankshaft position, engine speed and injector pulse width. The engine will not start or run if this circuit is open or grounded.
^ Reference Low- his wire is grounded through the ICM and insures that the ground circuit has no voltage drop between the ICM and the PCM which could affect performance. The PCM compares voltage pulses on the 7X or reference input to those on this circuit, ignoring any pulses that appear on both. A pulse that appears on the reference low circuit alone is assumed to be caused by radio frequency interference (RFI).
^ Ignition control (IC) 1 & 2-The PCM sends the ignition control pulse to the ICM on these circuits. These signals are similar to the 7X reference pulse square wave except that the PCM uses sensor inputs to determine the pulse timing to control spark advance. When the PCM receives the 7X signal, it will determine which pair of cylinders will be fired (1 & 4 or 2 & 3). It then tells the ICM which cylinder to fire through the ignition control circuits.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.