Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor: Service and Repair
REMOVAL PROCEDURE
1. Remove the air cleaner outlet resonator.
2. Remove the throttle body.
3. Remove the TP sensor attaching screws (1).
4. Remove the TP sensor (2) and seal (3).
INSTALLATION PROCEDURE
1. With the throttle valve in the normal closed (idle) position, install the throttle position sensor (2) and seal (3) on the throttle body assembly.
IMPORTANT: Install the new TP sensor attaching screws when replacing the TP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the two TP sensor screws (1).
Tighten
Tighten the screws to 3 N.m (27 lb in).
3. Install the throttle body.
4. Install the air cleaner outlet resonator.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
