2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

Park/Neutral Position Switch

Range Park/Reverse/Neutral/Overdrive/Drive 3/Drive 2/Low/Invalid
The scan tool displays the decoded position of the park/neutral position switch PRNDL inputs. This information is then sent by Class 2 serial data to the Instrument Panel Cluster (IPC) to be displayed to the operator on the IPC. If a valid combination of inputs is not seen by the PCM, Invalid will be displayed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.