Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Long Term FT
Range 0-255 (-100-100 Percent)
The Long Term Fuel Trim (FT) is derived from the short term fuel trim value. The Long Term Fuel Trim (FT) is used for the long term correction of the fuel delivery. A value of the 128 counts (0 percent) indicates that the fuel delivery requires no compensation in order to maintain a 14.7:1 air to fuel ratio. A value below 128 counts means that the fuel system is too rich and the fuel delivery is being reduced. The PCM is decreasing the injector pulse width. A value above 128 counts indicates that a lean condition exists for which the PCM is compensating.
The Long Term Fuel Trim (FT) is derived from the short term fuel trim value. The Long Term Fuel Trim (FT) is used for the long term correction of the fuel delivery. A value of the 128 counts (0 percent) indicates that the fuel delivery requires no compensation in order to maintain a 14.7:1 air to fuel ratio. A value below 128 counts means that the fuel system is too rich and the fuel delivery is being reduced. The PCM is decreasing the injector pulse width. A value above 128 counts indicates that a lean condition exists for which the PCM is compensating.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
