2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

General Information

PCM DATA DESCRIPTION
The following information will assist in diagnosing emission or driveability problems. The technician can view the displays while driving the vehicle. Refer to A Powertrain On Board Diagnostic (OBD) System Check in Computers and Control Systems for additional information. Initial Inspection and Diagnostic Overview

The displayed data messages on the scan tool are divided into the Engine, the Specific Engine, and the DTC lists as follows:

ENGINE DATA
^ Engine 1 - Contains general information regarding the fuel delivery, the Ignition Control (IC), the Knock Sensor (KS), the Evaporative Emission ([1][2]EVAP) and the basic engine operating conditions.
^ Engine 2 - Contains general information regarding the fuel delivery output controls, the ignition control (IC), the Air Conditioning (A/C), the cruise control, and the basic engine operating conditions.

SPECIFIC ENGINE DATA
^ [1][2]EVAP - Contains the information that is specific to the evaporative emissions (EVAP) system diagnosis and the data that is required in order to verify the proper operation of the system.
^ Misfire - Contains the information that is specific to the diagnosis of the misfire and the data that is required in order to verify the proper operation with reguard to the misfire.
^ O2S - Contains the information that is specific to the oxygen sensor (O2S 1) and the rear heated oxygen sensor (HO2S 2) diagnosis and the data that is required in order to verify the proper operation of the sensors.

DTC DATA
^ Freeze Frame-Contains the information that was collected during the time that a Malfunction Indicator Lamp (MIL) requesting Diagnostic Trouble Code (DTC) was set. This allows the technician to re-create the conditions when a fault occurred and to verify the proper operation within these conditions.
^ Failure Records-Contains the information at the time a diagnostic test failed and set a DTC. The failure records data is not necessarily associated with the MIL.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.