Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Cruise
Range Engage/Disengaged
The Stepper Cruise display indicates if the PCM is allowing the cruise operation. The PCM has the ability to disable the cruise control under certain conditions.
Cruise engaged is an input from the cruise control module to the PCM and indicates if the cruise control system is in control of vehicle speed. The PCM uses this information to change transmission shift calibrations and to turn ON an indicator lamp on the Instrument Panel Cluster (IPC) (when equipped). Refer to A Diagnostic System Check - Cruise Control in Cruise Control. Testing and Inspection
The Stepper Cruise display indicates if the PCM is allowing the cruise operation. The PCM has the ability to disable the cruise control under certain conditions.
Cruise engaged is an input from the cruise control module to the PCM and indicates if the cruise control system is in control of vehicle speed. The PCM uses this information to change transmission shift calibrations and to turn ON an indicator lamp on the Instrument Panel Cluster (IPC) (when equipped). Refer to A Diagnostic System Check - Cruise Control in Cruise Control. Testing and Inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
