2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

Body Control Module: Service and Repair

Factory service manual diagram



REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Release the BCM wire harness retainer (3) from the BCM Bracket (4).
3. Remove the BCM (1) from the BCM bracket (4).

INSTALLATION PROCEDURE
1. Install the BCM (1) to the BCM bracket (4).
2. Install the BCM wire harness retainer (3) to the BCM bracket (4).

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

3. Connect the negative battery cable.
4. Use the Tech 2 Scan Tool to reprogram the new BCM. Programming and Relearning
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.