2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

Front Caster 4.3 Degrees (deg)
+/- 1.00 Degrees
Front Camber 0.00 Degrees (deg)
+/-1.00 Degrees
Individual Toe
Measure the above toe angles with the steering wheel at level position, visually aligned with the column.
0.00 Degrees (deg)
+/- 0.12 Degrees
Sum Toe 0.00 Degrees (deg)
+/- 0.25 Degrees
Cross Camber
Slight cross camber specification differences can be made when servicing the vehicle for steering pull.
0.00 Degrees (deg)
+/- 1.00 Degrees
Cross Caster 0.00 Degrees (deg)
+/-1.00 Degrees
Rear Camber -0.40 Degrees (deg)
+/- 0.75 Degrees
Rear Sum Toe 0.20 Degrees (deg)
+/- 0.30 Degrees
Rear Thrust Angle 0.00 Degrees (deg)
+/- 0.25 Degrees
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.