Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Alignment: Service and Repair
FRONT CASTER ADJUSTMENT
The front caster is not adjustable. If the front caster angle is not within specifications, inspect for suspension support misalignment or front suspension damage. Replace any damaged suspension components as necessary.
FRONT CAMBER ADJUSTMENT

1. Loosen both strut to knuckle nuts just enough to allow for movement.
2. If the strut has not been modified previously, perform the following steps before continuing with the wheel alignment:
2.1. Disconnect the strut from the knuckle. Refer to Strut Assembly Replacement.
2.2. File the lower hole until the outer flange slot matches the inner flange slot.
2.3. Connect the strut to the knuckle. Refer to Strut Assembly Replacement.

3. Adjust the camber to specification by moving the top of the wheel in or out.
FRONT TOE ADJUSTMENT

1. Ensure that the steering wheel is set in a straight ahead position.
2. Loosen the tie rod jam nut (5).
3. Adjust the toe to specification by turning the adjuster (6). Refer to Wheel Alignment Specifications.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the tie rod jam nut (5).
- Tighten the tie rod jam nut (5) to 68 Nm (50 ft. lbs.).
Rear wheel alignment is not adjustable. If the rear camber and toe angles are not within specifications, inspect for underbody or suspension damage.
The front caster is not adjustable. If the front caster angle is not within specifications, inspect for suspension support misalignment or front suspension damage. Replace any damaged suspension components as necessary.
FRONT CAMBER ADJUSTMENT
1. Loosen both strut to knuckle nuts just enough to allow for movement.
2. If the strut has not been modified previously, perform the following steps before continuing with the wheel alignment:
2.1. Disconnect the strut from the knuckle. Refer to Strut Assembly Replacement.
2.2. File the lower hole until the outer flange slot matches the inner flange slot.
2.3. Connect the strut to the knuckle. Refer to Strut Assembly Replacement.
3. Adjust the camber to specification by moving the top of the wheel in or out.
FRONT TOE ADJUSTMENT
1. Ensure that the steering wheel is set in a straight ahead position.
2. Loosen the tie rod jam nut (5).
3. Adjust the toe to specification by turning the adjuster (6). Refer to Wheel Alignment Specifications.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the tie rod jam nut (5).
- Tighten the tie rod jam nut (5) to 68 Nm (50 ft. lbs.).
Rear wheel alignment is not adjustable. If the rear camber and toe angles are not within specifications, inspect for underbody or suspension damage.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
