Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Cruise Control Module: Service and Repair
REMOVAL PROCEDURE

1. For the 2.4L only, remove the cruise control cable cover.
2. Remove the cruise control cable from the throttle body control bracket.
3. Remove the cruise control cable from the throttle body cam.
4. Remove the cruise control cable from the module by turning the cable assembly 1/4 turn counterclockwise.

5. Remove the cable from the ribbon.
6. Disconnect the electrical connector from the module assembly.

7. Unclip the hinged retaining strap from the bracket at the top of the module.
8. Remove the module from the mounting bracket.
INSTALLATION PROCEDURE

1. Install the module assembly to the mounting bracket.
2. Connect the electrical connector to the module.

3. Connect the cruise control cable to the module ribbon.

4. Install the cruise control cable to the module assembly by turning the cable assembly 1/4 turn clockwise.

5. Install the cruise control cable to the throttle body control bracket.
6. Install the cruise control cable to the throttle body cam.
7. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment or Cruise Control Cable adjustment
8. For the 2.4L only, install the cruise control cable cover.
9. Perform A Diagnostic System Check. Refer to A Diagnostic System Check Cruise Control.
1. For the 2.4L only, remove the cruise control cable cover.
2. Remove the cruise control cable from the throttle body control bracket.
3. Remove the cruise control cable from the throttle body cam.
4. Remove the cruise control cable from the module by turning the cable assembly 1/4 turn counterclockwise.
5. Remove the cable from the ribbon.
6. Disconnect the electrical connector from the module assembly.
7. Unclip the hinged retaining strap from the bracket at the top of the module.
8. Remove the module from the mounting bracket.
INSTALLATION PROCEDURE
1. Install the module assembly to the mounting bracket.
2. Connect the electrical connector to the module.
3. Connect the cruise control cable to the module ribbon.
4. Install the cruise control cable to the module assembly by turning the cable assembly 1/4 turn clockwise.
5. Install the cruise control cable to the throttle body control bracket.
6. Install the cruise control cable to the throttle body cam.
7. Adjust the cruise control cable. Refer to Cruise Control Cable Adjustment or Cruise Control Cable adjustment
8. For the 2.4L only, install the cruise control cable cover.
9. Perform A Diagnostic System Check. Refer to A Diagnostic System Check Cruise Control.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
