Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Hardware Attachment Threadlocking
All door hardware production attaching screws contain an epoxy thread-locking compound in order to maintain the minimum original torque setting. Service attaching screws may not contain a thread-locking compound. Apply GM P/N 12345493 (or equivalent) to the hardware attachment as a liquid in order to treat the threads of fasteners for the following reasons:
^ In order to prevent loosening of service screws
^ In order to renew the thread-locking characteristics of production screws
After you install and tighten the screws, the adhesive cures. The curing process is necessary for the following reasons:
^ In order to bond the attachment to the screw
^ In order to prevent loosening of the screw
^ In order to prevent backing out of the screw The adhesive bond does not prevent future attachment removal if required. You may use LOCTITE(TM) 272 (or equivalent) on any thread fastener.
^ In order to prevent loosening of service screws
^ In order to renew the thread-locking characteristics of production screws
After you install and tighten the screws, the adhesive cures. The curing process is necessary for the following reasons:
^ In order to bond the attachment to the screw
^ In order to prevent loosening of the screw
^ In order to prevent backing out of the screw The adhesive bond does not prevent future attachment removal if required. You may use LOCTITE(TM) 272 (or equivalent) on any thread fastener.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
