Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter: Service and Repair
Up to four transmitters may be programmed to one remote control door lock receiver. A transmitter may be programmed to more than one vehicle if the remote keyless entry systems are similar. All of the transmitters (maximum of 4 total per receiver) must be programmed at the same time in order for all of the transmitters to function properly.
IMPORTANT:
^ Leave a window down in the vehicle while reprogramming the remote control door lock receiver system. The above action will prevent unintentional lock out if the reprogramming procedure is not performed properly.
^ The Tech 2 must be used to program transmitters. Transmitters may be deleted in the event of a theft and new transmitters added using the Tech
1. Turn the ignition to the ON position with the engine OFF.
2. Using the Tech 2, program the transmitter. The following indicators indicate that the module is ready to be programmed:
^ The door locks will lock. The door locks will unlock.
^ The rear compartment lid release will cycle.
^ The horn chirp will sound.
The above conditions should occur within 2.seconds.
3. Press and hold the LOCK and the UNLOCK buttons simultaneously until the following conditions occur:
^ The door locks lock.
^ The door locks unlock.
^ The rear compartment lid release releases.
^ The horn chirp sounds.
The above conditions should occur in approximately 12 seconds. The above conditions verify successful transmitter reprogramming.
4. Perform the previous step for each of the remaining transmitters.
5. Verify the proper operation of each transmitter.
IMPORTANT:
^ Leave a window down in the vehicle while reprogramming the remote control door lock receiver system. The above action will prevent unintentional lock out if the reprogramming procedure is not performed properly.
^ The Tech 2 must be used to program transmitters. Transmitters may be deleted in the event of a theft and new transmitters added using the Tech
1. Turn the ignition to the ON position with the engine OFF.
2. Using the Tech 2, program the transmitter. The following indicators indicate that the module is ready to be programmed:
^ The door locks will lock. The door locks will unlock.
^ The rear compartment lid release will cycle.
^ The horn chirp will sound.
The above conditions should occur within 2.seconds.
3. Press and hold the LOCK and the UNLOCK buttons simultaneously until the following conditions occur:
^ The door locks lock.
^ The door locks unlock.
^ The rear compartment lid release releases.
^ The horn chirp sounds.
The above conditions should occur in approximately 12 seconds. The above conditions verify successful transmitter reprogramming.
4. Perform the previous step for each of the remaining transmitters.
5. Verify the proper operation of each transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
