Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Sunfire L4-2.2L VIN 4FACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter Battery: Service and Repair
REMOVAL PROCEDURE
Perform the following steps in order to open the transmitter case:
1. Insert a small flat-bladded tool between the
2 halves of the transmitter case at the slot provided near the key ring (5) hole.
2. Twist the tool in order to open the case (6, 4).
3. Remove the battery (2).
INSTALLATION PROCEDURE
1. Install the battery (2) with the positive (+) side facing down.
Use one 3-volt CR2032 battery or the equivalent.
2. Ensure the transmitter case seal is in the proper position.
3. Align the 2 halves of the transmitter case (6, 4).
4. Snap the 2 halves of the transmitter case together.
IMPORTANT: Normal battery life is approximately 2 years. Replace the batteries when the range of the transmitter begins to decrease significantly to less than approximately 7 m (23 ft).
5. Test the operation of the transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
