Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Pontiac Firefly (CANADA) L4-1.3LFACTORY OEM SERVICE PROCEDURE
Speedometer Module: Service and Repair
REMOVAL PROCEDURE
NOTE: When replacing a speedometer or odometer assembly, federal law requires that the odometer reading of the replacement unit be set to register the same mileage as the prior odometer. If the same mileage cannot be set, the law requires that the replacement odometer be set at zero and a label be installed on the driver's door frame to show the previous reading and the date of replacement.
1. Remove the instrument cluster from the instrument panel.
2. Push on the tabs in order to remove the cluster lens (7) and the bezel assembly (6) from the cluster housing.
3. Remove 4 screws (2) that secure the speedometer to the cluster housing.
4. Remove the speedometer gauge (5) from the cluster housing (3).
INSTALLATION PROCEDURE
1. Install the speedometer gauge (5) to the cluster housing (3).
2. Secure the speedometer gauge to the cluster housing with 4 screws (2).
3. Install the cluster lens (7) and the bezel (6) to the cluster housing (3).
4. Install the instrument cluster to the instrument panel.
NOTE: When replacing a speedometer or odometer assembly, federal law requires that the odometer reading of the replacement unit be set to register the same mileage as the prior odometer. If the same mileage cannot be set, the law requires that the replacement odometer be set at zero and a label be installed on the driver's door frame to show the previous reading and the date of replacement.
1. Remove the instrument cluster from the instrument panel.
2. Push on the tabs in order to remove the cluster lens (7) and the bezel assembly (6) from the cluster housing.
3. Remove 4 screws (2) that secure the speedometer to the cluster housing.
4. Remove the speedometer gauge (5) from the cluster housing (3).
INSTALLATION PROCEDURE
1. Install the speedometer gauge (5) to the cluster housing (3).
2. Secure the speedometer gauge to the cluster housing with 4 screws (2).
3. Install the cluster lens (7) and the bezel (6) to the cluster housing (3).
4. Install the instrument cluster to the instrument panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.