2000 Pontiac Firefly (CANADA) L4-1.3LFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

Factory service manual diagram



1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the electrical connector from the Crankshaft Position (CKP) sensor.
3. Remove the bolt and the CKP sensor from the oil pan.

Factory service manual diagram



4. Inspect the CKP sensor signal rotor for damaged teeth or for missing teeth through the CKP sensor opening.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Install the CKP sensor to the engine block.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Secure the CKP sensor with the bolt.

Tighten
Tighten the CKP sensor bolt to 10 N.m (89 lb in).

4. Connect the CKP sensor electrical connector.
5. Lower the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.