2000 Pontiac Firefly (CANADA) L4-1.3LFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

Factory service manual diagram



1. Disconnect the electrical connector from the Camshaft Position (CMP) sensor.
2. Remove the bolt and the CMP sensor.

Factory service manual diagram



3. Use a mirror in order to inspect the CMP sensor signal rotor (2) for damage.

INSTALLATION PROCEDURE

Factory service manual diagram



1. Install the CMP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Secure the CMP sensor with the bolt.

Tighten
Tighten the CMP sensor bolt to 10 N.m (89 lb in).

3. Connect the CMP sensor electrical connector.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.