Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shift Control Cable
Position the transmission shift control lever into Park. Apply the park brake. Raise and support the vehicle. Position the transmission range selector lever to Park. Rotate the range select lever clockwise until it reaches the full mechanical stop position. Install the transmission shift cable into the bracket with the cable adjustment button up. Install the shift cable to the range selector lever pin. Press cable adjustment button down. Insert the retainer to the shift cable. See Fig 1 . Lower the vehicle.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.