Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Entering Programming Mode
Turn ignition switch to ON position to disarm system. Turn ignition off. Remove 15-amp RADIO fuse No. 17 located in instrument panel fuse block behind left side of dash. Turn ignition switch to ACC position. Chime will sound, indicating programming mode has been entered.
One chime indicates exit lighting, delayed illumination, last door closed locking and lockout prevention can be customized. Two chimes indicate remote lock control verification, arming method, arming verification, driver's door delay and shock sensor enable/disable can be customized.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.