1997 Pontiac Firebird Formula, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
A/C Pressure Sensor Above Right Shock Tower, In Front Of A/C Compressor Low Pressure Cut-Off Switch
Body Control Module On HVAC Module, Above Right Instrument Panel Insulator Panel
Camshaft Position (CMP) Sensor On Engine Front Cover, Above Oil Filter
Crankshaft Position (CKP) Sensor At Lower Left Front Cover Of Engine, Behind Harmonic Balancer
Cruise Control Module At Left Front Frame Rail, In Front Of Wheelwell
Data Link Connector On Instrument Panel Tie Bar, Right Of Steering Column
EGR Valve At Left Front Of Engine, Next To Engine Lift Bracket
Engine Coolant Temperature (ECT) Sensor At Lower Front Of Intake Manifold, Under Throttle Body
Engine Oil Level Sensor Center Of Engine On Oil Pan
EVAP Canister Purge Solenoid At Right Center Of Engine, On Intake Manifold
EVAP Canister Vacuum Switch Top Right Of Engine, Part Of EVAP Canister
Fuel Injectors In Intake Manifold
Fuel Pressure Regulator At Left Rear Of Engine, Above Valve Cover
Fuel Pump Prime Connector At Top Rear Of Right Shock Tower
Fuel Pump Relay In Front Of Left Kick Panel, On Footrest Bracket, Under Carpet
Idle Air Control (IAC) Valve Top Of Engine, Above Throttle Position Sensor
Ignition Control Module On Left Side Of Engine, Above Valve Cover
Intake Air Temperature (IAT) Sensor On Air Duct, In Front Of Intake Manifold
Knock Sensors On Left & Right Side Of Engine
Manifold Absolute Pressure (MAP) Sensor Right Rear Of Intake Manifold, Above Valve Cover
Mass Airflow (MAF) Sensor On Top Front Of Throttle Body, Above Water Pump
Oxygen Sensors (O2S) In Exhaust Manifolds & In Exhaust Pipe In Front & Rear Of Catalytic Converter
Powertrain Control Module (PCM) In Engine Compartment, Behind Right Shock Tower
Throttle Position (TP) Sensor On Right Front Of Throttle Body
Transmission Range Switch Under Console, At Base Of Shift Lever
Underhood Electrical Centers At Left Side Of Engine Compartment, In Front Of Wheelwell
Vehicle Speed Sensor On Rear Of Transmission
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.