1996 Pontiac Grand Prix BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
Blower Motor Control Module Behind right side of dash, under right side of plenum.
Cellular Mobile Telephone Transceiver On right front corner of rear compartment.
Chime Module Behind right side of dash.
Cruise Control Module (3.1L VIN M) On left strut tower. See Figure.
Cruise Control Module (3.8L VIN K) On left strut tower. See Figure.
Daytime Running Lamps (DRL) Control Module Behind left side of dash, on brake pedal support.
Electronic Brake Control Module Behind dash, left of brake pedal bracket.
Engine Coolant Level Indicator Module On right side of radiator.
Fuel Pump Module Mounted to fuel pump.
Ignition Control Module (3.1L VIN M) Top of engine. See Figure.
Ignition Control Module (3.4L VIN X) Top of engine. See Figure.
Ignition Control Module (3.8L VIN K) Top of engine. See Figure.
Low Frequency Audio Amplifier Behind dash, right of steering column.
PAC Module Behind radio.
Powertrain Control Module (PCM) (3.1L VIN M) On right side of engine compartment, forward of strut tower. See Figure.
Powertrain Control Module (PCM) (3.4L VIN X) On right side of engine compartment, forward of strut tower. See Figure.
Powertrain Control Module (PCM) (3.8L VIN K) On right side of engine compartment, forward of strut tower. See Figure.
Remote Control Door Lock Receiver (Buick, Oldsmobile & Pontiac) Below right rear window trim panel.
Remote Control Door Lock Receiver (2-Door Buick) Behind right rear quarter trim.
Remote Control Door Lock Receiver (Chevrolet) At right kick panel.
Sensing & Diagnostic Module (SDM) Below right front seat.
Theft Deterrent Module Behind dash, above glove box.
Turn/Hazard Flasher Module Behind left side of dash, mounted in firewall.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.