Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Pontiac Firebird Formula, AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location | |
|---|---|---|
| ABS Module | Behind left side of dash, near kick panel. | |
| Audio Alarm Module | In convenience center. | |
| Cruise Control Module | In engine compartment, on left frame rail, forward of wheelwell. | |
| Daytime Running Lights (DRL) Module | Behind center of dash, above A/C-heater duct. | |
| Diagnostic Energy Reserve Module (DERM) | Behind dash, near glove box. | |
| Electronic Ignition Module (3.4L) | At front end of left cylinder head. | |
| Engine Control Module (ECM) | ||
| 3.4L (VIN S) | In right rear corner of engine compartment. See Figure . | |
| 5.7L (VIN P) | In right rear corner of engine compartment. See Figure . | |
| Express Window Down Module | On center of dash mat, above floor tunnel. | |
| Headlight Doors Module (Firebird) | In engine compartment, forward of left wheelwell. | |
| Ignition Coil Module (5.7L) | At front end of left cylinder head. See Figure . | |
| Keyless Entry Receiver (Firebird) | Behind right kick panel. | |
| PASS-Key Decoder Module | Behind dash, to left of glove box. | |
| Power Seat Control Module (Firebird) | Under driver's seat. | |
| Retained Accessory Power (RAP) Module | On center of dash mat, above floor tunnel. | |
| Wiper Motor Module | Mounted on wiper motor assembly. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.