Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Pontiac LeMans VLFACTORY OEM SERVICE PROCEDURE
Diagnostic Aids
The following conditions are probable causes of Code 45:
- Fuel pressure is too high. ECM can compensate for some increase in fuel pressure; however, if fuel pressure gets too high, Code 45 will set.
- An open in distributor ground circuit (Black/White wire) may result in electrical noise interference, causing a faulty high engine RPM signal to ECM. The ECM will supply too much fuel, causing system to run rich. Engine tachometer will also indicate higher values than actual values.
- Check for fuel saturation of canister and for faulty canister purge control.
- A false MAP sensor signal, indicating lower vacuum than normal manifold vacuum, can cause system to run rich, setting Code 45. Disconnecting MAP sensor will allow ECM to set a fixed value for the MAP sensor. If rich condition goes away when MAP sensor is disconnected, substitute a known good MAP sensor.
- An intermittent TPS signal, giving false indication of engine acceleration, will cause rich exhaust and Code 45 to set.
- A contaminated O2 sensor will provide a false high reading to ECM. The ECM will reduce fuel delivery, causing a severe surge driveability problem.
- EGR valve sticking or leaking will cause dilution of exhaust gases, and will cause ECM to richen fuel system mixture. If Code 45 is intermittent, see INTERMITTENTS in TESTS W/O CODES article in this section.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
