Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Pontiac LeMans VLFACTORY OEM SERVICE PROCEDURE
Ignition Coil Testing
- Using an ohmmeter, check resistance between B+ terminal and base of ignition coil. See Fig 1 . Reading should be high or infinite (open circuit). If resistance is not high or infinite, replace ignition coil.
- Check resistance between B+ and C- terminals. Reading should be about 0.5 ohm. Check resistance between C+ terminal and coil secondary terminal. Reading should be about 8300 ohms.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.