1992 Pontiac Firebird Formula, 5.0 F, AutomaticFACTORY OEM SERVICE PROCEDURE

Basic Ignition System Checks (C4): IDI: Spark

WARNING: This page does not describe the selected car, but rather 34 other vehicles, including the 1991 Pontiac Sunbird, 1991 Pontiac Grand Prix, 1991 Pontiac Grand Am, 1991 Pontiac Firebird, and 1991 Pontiac Bonneville. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect tachometer wire from IDI module (if equipped). A shorted tachometer will not allow vehicle to start. Temporarily remove IDI assembly and install spark plug Jumper Wires (J-36012). Check for adequate spark with Spark Tester (ST-125). Check for spark on 2 adjacent plug wires (1-2 or 3-4, not 2-3). Leave matching plug wire connected while checking for spark. When removing spark plug wire from spark plug, twist and pull on boot. DO NOT pull on wire.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.