Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC19916000 SEREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTSFUEL SYSTEMFUEL CONTROLFUEL INJECTOR(S)
1991 Pontiac 6000 SE
Fuel Injector(s)
1991 Pontiac 6000 SESECTION Fuel Injector(s)
Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See FUEL INJECTOR RESISTANCE table.
FUEL INJECTOR RESISTANCE
| Application | (1) Ohms | ||||
|---|---|---|---|---|---|
| 2.0L (VIN K) | 1.6 | ||||
| 2.2L (VIN G) | 1.6 | ||||
| 2.3L (VIN A & D) | 1.9-2.1 | ||||
| 2.5L (VIN R & U) | 1.6 | ||||
| 3.1L (VIN T) | 12.0-12.4 | ||||
| 3.3L (VIN N) | (2) | ||||
| 3.4L (VIN X) | 12.0-12.4 | ||||
| 3.8L (VIN C) | (2) | ||||
| 5.0L (VIN E) | 1.2 | ||||
| 5.0L (VIN F) | 16.2 | ||||
| 5.7L (VIN 7) | 1.2 | ||||
| 5.7L (VIN 8) | 10.0 | ||||
|
|||||
NOTE:
If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing INJECTOR BALANCE TEST.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.