Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC19916000 SEREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGBASIC IGNITION SYSTEM CHECKS (C4)DIS IGNITIONSPARK
1991 Pontiac 6000 SE
Dis Ignition: Spark
1991 Pontiac 6000 SESECTION Spark
- If factory tachometer is connected to ignition coil tachometer terminal, disconnect it before performing tests. When removing spark plug wire from spark plug, twist and pull on boot, NOT on wire.
- Using Spark Tester (ST-125), check for spark at each spark plug wire using spark tester. Leave opposed firing plug connected while checking for spark. Check spark plug wire resistance on suspect wires. Resistance should be no greater than 30,000 ohms.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.