Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Pontiac Sunbird GT, 2D Convertible, 2.0 K, StandardFACTORY OEM SERVICE PROCEDURE
Code 14, Coolant Temp Sensor Signal Volt Low: Notes
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Checks to see if code was set as a result of a hard failure or an intermittent condition. Code 14 will set if engine has been running for more than 10 seconds and signal voltage indicates a coolant temperature more than 275°F (135°C) for more than 3 seconds.
- This test simulates conditions for a Code 15. If the ECM recognizes the open circuit by displaying a low temperature, ECM and wiring are not at fault.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.