Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Pontiac Fiero Formula, AutomaticFACTORY OEM SERVICE PROCEDURE
Digital EGR Valve
- Turn engine off. Disconnect EGR connector. Using Tool Kit (J-35616), install jumper harness connector terminal "D" to terminal "D" of EGR valve. Connect jumper to ground. Start engine. Engine RPM should change as each EGR valve terminal "A", "B" or "C" is contacted. For terminal location, see appropriate diagnostic chart in COMPUTER COMMAND CONTROL article.
- If engine RPM does not change, check for restriction in EGR supply tube or plugged EGR orifice. If EGR valve is not restricted or plugged, replace EGR valve. If engine RPM does change, digital EGR valve is functioning properly. If further testing is required, see appropriate diagnostic chart in COMPUTER COMMAND CONTROL article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.